Operating the Condo Electronics

Televisions

Each television set has a black remote control assigned to it located in the same room as the television. If the remote control is not functioning properly, please notify the front desk.

Fireplaces

The fireplace located in the main living area is a touch screen fireplace. There are three buttons located under the viewing window on the right side. The button furthest to the left is the Power button and is used to power to device on and off. The middle button is the Heat control and it has three heat levels which can be cycled with each press. The button furthest to the right is the Dimmer, press this button to adjust the brightness of the display or turn the display off, while still using the fireplace to provide heat.

Heating/Air Conditioning Units

Each heating/air conditioning unit is present in each room. We ask that you do not adjust the predetermined settings of this unit, however, if you are finding the room temperature not to your liking, you can adjust it with the beige “Mitsubishi Electric” remote, holstered on the wall. The remote should be pointed at the white heating/air conditioning unit. When making changes, you will be notified by a beep when a successful change has been made. There are three buttons for the desired usage. The red button is to power on/off the heating/air conditioning unit. The arrow button pointing down is to lower the temperature, and the arrow button pointing up is to increase the temperature.

Please Note: Please allow a few minutes for the change to take effect, as the temperature change will not take place immediately.

Air Jet Bathtubs

The tubs have automatically activated air jets. You are not required to turn them on or off, as they will activate on their own. These air jets are present to provide the most relaxing and comfortable experience for our guests. They will sometimes turn off without water. This is nothing to worry about, this is due to purging of the lines.

Stelpro Heating

All Thermostats are set to Automatic (Auto)

From the Automatic mode, the thermostat adjusts the set points according to the programmed periods. The thermostats standard factory set point in 21 degrees Celsius. It is always possible to manually adjust the set point using the + or – button.

Vanee Ventilation

20 - Minutes Push Button Switch

This timer allows the unit to provide 20 minutes of high-speed ventilation at the push of a button, to rapidly expel stale indoor air. The LED light indicates that the timing is engaged.